Jungle Flasher Not Detecting

[ChandlerD]

Im helping a friend flash his benq over teamviewer ( I can see his computer via mine) he has xp , we hooked the benq up with the via 6421 sata and started jungle 4.3 and it detects the via but it says no drive detected.

[sadalius]

did he put the drive in half closed state?

[ChandlerD]

Nope i never did that before how do u do it

[Backslash]

Make sure the port is correct, and it will be called VAD6038

If you look in MTKFlash, and when BenQ unlock doesnt work, then you can hit Intro/Device ID, and when u hit ok, turn off the drive, then wait 2 sec, and turn back on. That will put you in Vendor mode.. Although BenQ unlock will work with stock Drives. Ixtreme 1.4-1.5's FirmGuard is pretty tough.

[ChandlerD]

how do I leave the drive half open????

[Backslash]

u dont have to have it half open, but if u have a VIA or nForce chipset this will work for you. Read the post above

[CoFree]

how do I leave the drive half open????

as long as you are powering the dvd drive wuth a ck3 kit
hit the eject button.
cut the power off on the ck3
push the dvd drive tray in half(or just a little more)
then turn the ck3 power back on.

[ChandlerD]

im not using that , can i still do it?

[Backslash]

you got both the answers right there man..

[CoFree]

it will just stay open

if you are trying to power the dvd drive with the console then its a pain in the back side.
is that what you are doing
or do you have a ck3 of some kind

[CoFree]

have a read here.

If using a 360 to power the drive this method can be tricky to accomplish.
You need to power on the drive with Eject status closed but Tray Half Open –To do this using
an Xbox 360 as Power source, eject the DVD drive, then, press eject to ‘close’ the tray. Now this
is the important part –you MUST remove the DVD power plug from the DVD Drive BEFORE it
closes fully.
Wait for a few seconds and replace the power plug into the DVD drive taking extreme caution
to plug the plug the right way around –once done, the drive is now powered, console thinks its
closed but it is in fact half open.

[ChandlerD]

Got the drive done all I had to do was re install port32

[Backslash]

Nice job

[CoFree]

cool
good job