sammy ms25 1.6 to 1.61

[killingtime]

how would i go about flashing from 1.6 to 1.61, i used iprep on 1.6 i would like to do it with jungleeflasher with 1.61

[HaGGardSmurf]

Hook up the drive, eject thetray half way, click intro/device ID, read the drive, then load your target FW, click spoof source to target, write to the drive, verify, click outro.

Thats every step in order, to use jungle to flash the drive.

[killingtime]

so i dont have to worry about drive key cause its already flahed

[HaGGardSmurf]

Well when you read the drive, it dumps the FW from the drive, you can save it to be safe, but you should have your real OFW somewhere.

Anyways, once it reads the drive, it will automatically load the FW as source, then all you need to do is auto load or click open target FW. If you want to auto load 1.61 must be in the FW folder. Also I am not sure if JF will auto load 1.61 or will just load 1.6.

[killingtime]

so basically u are saying that i dont have to worry about it already being flashed i just load up the new firmware and thats it ?