Page 1 of 1
Does my OBD Work?
Posted: Fri Feb 27, 2009 9:16 pm
by HaGGardSmurf
How can I test this?
I swapped my HDD to motherboard sata with the sata that comes in your 360. So I have my drive connected to my motherboard, and am going to use the 360's power. I have the cases touching, my drive is an ms28.
How do I see if my OBD can read my FW? How do I do this?
Re: Does my OBD Work?
Posted: Fri Feb 27, 2009 9:22 pm
by Backslash
By OBD you mean the
Onboard SATA? If you do then all you need to do is load up
iPrep or
JungleFlasher whichever u are using, if in iPrep, dsam XXXXXXX XXXXX then hit OK and if it lists drive, then it recognizes it. If in JungleFlasher, you need to choose the port which its on, and look and see if your mS28 is listed. Its as simple as that.
Re: Does my OBD Work?
Posted: Fri Feb 27, 2009 9:30 pm
by HaGGardSmurf
Yea thats what I mean.
So I have it connected and turned on, how do I do it with jungle flasher? What tab to I go to what do I click etc?
Re: Does my OBD Work?
Posted: Fri Feb 27, 2009 9:33 pm
by Backslash
Since its an MS28, go to MTKFlash and choose the port, in I/O Port, if its the Samsung Drive, it will say so in the drive properties just below it.
Have a look at this and download it
viewtopic.php?f=197&t=3724
Re: Does my OBD Work?
Posted: Fri Feb 27, 2009 9:36 pm
by HaGGardSmurf
Ok, so then my on board doesnt detect it, I went to MTK 32, and tried all ports and it says no drive detected for all of them.
Also, when I power on my drive, it makes a loud noise at first, did something go wrong?
(Good thing my motherboard doesnt recognize it because I already bought the VIA chipset
)
Re: Does my OBD Work?
Posted: Fri Feb 27, 2009 9:38 pm
by Backslash
Umm I don't know what the noise would be from but I think u should be fine. And when u use the VIA chipset, hook your SATA cable to the SATA port closest to the front of the case, that's the hot 1.
Re: Does my OBD Work?
Posted: Fri Feb 27, 2009 9:56 pm
by HaGGardSmurf
Alright, good to know!
Why would my HDD be connected to the one farthest back? Does this matter?
The xbox boots fine, green lights etc, so I will reposition the drive, and test it see if the xbox makes this weird sound. Could have been since my drive was tilted.
Re: Does my OBD Work?
Posted: Fri Feb 27, 2009 10:00 pm
by Backslash
When i said the closest to the front i meant for the VIA card the one next to the motherboard not the external and not the side one.
Re: Does my OBD Work?
Posted: Fri Feb 27, 2009 10:03 pm
by HaGGardSmurf
Oh alright
My xbox started fine, no noises when I re positioned the drive, must have been the position it was in.
So now the wait for my VIA card begins
