NWP Questions.
Posted: Sat Nov 27, 2010 9:28 pm
I think this is considered V 1 ↓↓↓
I think this is considered V 2 ↓↓↓
You can see what's less work.
I'm going to do V 1. Questions....
What wire to use ? knyar wire, too small, too big (1 mm...) (1.5mm..) ??? ( The pins are so tiny)
Would there be any effect on the motherboard if i use glue from the glue gun to tack the wire to the board ??? ( Takes the strain from the NAND just incase the knayar wire does get caught and tugged on )
Then i'm going to get a small toggle switch, mount that to the side of the case, and you no the rest
I think this is considered V 2 ↓↓↓
You can see what's less work.
I'm going to do V 1. Questions....
What wire to use ? knyar wire, too small, too big (1 mm...) (1.5mm..) ??? ( The pins are so tiny)
Would there be any effect on the motherboard if i use glue from the glue gun to tack the wire to the board ??? ( Takes the strain from the NAND just incase the knayar wire does get caught and tugged on )
Then i'm going to get a small toggle switch, mount that to the side of the case, and you no the rest