Robin Hoods Playground

can i use jungleflasher and choose the dummy from ixtreme to update from the old version(i think it was called lt 1.1) to lt+
or do i have to use the key.bin i have from the last update i did(from iextreme to lt 1.1)?
Thanks in advance

The only way you can read the firmware off your drive once its been flashed with LT is by doing an MRA hack. (MRA hack is done by cutting traces, and then bridging them at certain points during the flashing)

I'd reccomend just using your key.bin or dummy.bin from before, and injecting it into LT+, then flash that. No need to make it harder than it has to be.