Page 1 of 1
first flash with 1.61 on benq
Posted: Mon Dec 14, 2009 7:12 pm
by shaky
trying to flash a benq with new iprep and 1.61 , i followed the vid but i am getting error message after reading banks
Re: first flash with 1.61 on benq
Posted: Mon Dec 14, 2009 7:18 pm
by CoFree
try a different usb flash drive and
make sure you are on a via6421a or l chipset
Re: first flash with 1.61 on benq
Posted: Tue Dec 15, 2009 4:48 pm
by shaky
my card is a VIA6421a on the box but when i open iprep in sata controller it says VIA VT6421 and my old mem stick is a 1gig my new one is a 2gig does that matter or not
Re: first flash with 1.61 on benq
Posted: Tue Dec 15, 2009 11:27 pm
by CoFree
2gb is fine but try not to use one larger than that
Re: first flash with 1.61 on benq
Posted: Wed Dec 16, 2009 5:10 pm
by shaky
so why am i getting error then it wont go past reading banks
Re: first flash with 1.61 on benq
Posted: Wed Dec 16, 2009 5:13 pm
by CoFree
man you will need to go into detail about what you ae doing and when it gives you the error
have you got a good dump of your firmware and you get the error when firmtool is going to start
Re: first flash with 1.61 on benq
Posted: Fri Dec 18, 2009 6:24 pm
by shaky
sorry my friend here goes , boot from mem stick type ben mel1 mel1 etc
this is the screen i am getting
reading banks 0
reading banks 1
reading banks 2 etc etc
reading banks finished datasum b84f
57697----------------------------------
firmtool v1-3-1 by caster420
no valid key found
check key range of backups
error
drive firmware reading failed
double check your conection and try again
Re: first flash with 1.61 on benq
Posted: Mon Dec 21, 2009 4:53 pm
by shaky
come on help please why am i getting this error
Re: first flash with 1.61 on benq
Posted: Mon Dec 21, 2009 6:03 pm
by djshauny1
shaky wrote:come on help please why am i getting this error
man when people are ready to answer they will.
shouting like that wont get u help im affraid
Re: first flash with 1.61 on benq
Posted: Sat Dec 26, 2009 3:18 pm
by shaky
djshauny1 wrote:shaky wrote:come on help please why am i getting this error
man when people are ready to answer they will.
shouting like that wont get u help im affraid
sorry mate i wasnt shouting just in a hurry to get it sorted
i have followed all instructions even changed my mem stick but sill getting erors